Right Crankcase Cover Removal; Stator Removal - KYMCO People Service Manual

10. A.C. GENERATOR/STARTER CLUTCH

RIGHT CRANKCASE COVER REMOVAL

Disconnect the water hoses from the water
pump cover. ( Öchapter 5 )
Disconnect the water hoses from the right
crankcase cover.
Remove the nine bolts attaching the right
crankcase cover and the cover.
Remove right crankcase cover.
RIGHT CRANKCASE COVER
REMOVAL(ENGINE INSTALLED)
Remove met-in box and frame body cover.
( Ö2-6 )
Disconnect the water hoses from the water
pump cover. ( Öchapter 5 )
Disconnect the water hoses from the right
crankcase cover. ( Öchapter 5 )
Disconnect A.C. generator wire coupler and
oil pressure switch wire. ( Öchapter 5 )
Remove the eight bolts attaching the right
crankcase cover and the cover.
Remove the left and right rear shock absorber
lower mount bolts. ( Öchapter 5 )
Elevate the back of engine as possible by
placing a suitable stand under the back of
engine.
Remove the bolt between water pump cover
and oil filter screen cap.
Remove right crankcase cover.
Support the machine securely so there is
no danger of it falling over.

STATOR REMOVAL

Remove the two pulser coil attaching screws
and the pulser coil.
Remove the three A.C. generator stator bolts
and the stator.
When removing the pulser coil and
stator, be careful not to damage them to
avoid shorted or broken wire.
10-3
PEOPLE/PEOPLE S 250
Bolts
Bolts
Bolt
Oil Filter Screen Cap
A.C. Generator Stator
Bolts
Water Pump Cover
Water Hose
Water Pump Cover
Screws
Pulser Coil