KYMCO People Service Manual page 189

14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Pack all bearing cavities with grease.
Drive in the left bearing.
Install the distance collar.
Drive in the right bearing.
x Do not allow the bearings to tilt while
driving them in.
x Drive in the bearing squarely with the
sealed end facing out.
Special Tools
Oil seal & bearing installer
INSTALLATION
Apply grease to the speedometer gear unit.
Install the speedometer gear unit by aligning
its retaining pawl with the hub cutout.
x If not aligned, the retaining pawl will be
deformed when the axle nut is
tightened.
x After installing the axle, turn the wheel
to make sure that the speedometer
drive shaft rotates freely.
Install the front wheel by aligning the
speedometer gear unit groove with the front
shock absorber tab.
Insert the axle and tighten the axle.
When installing the front wheel, position
the brake disk between the two brake
pads.
Torque: 29 35N-m
Install and tighten the two bolts.
Torque: 29 35N-m
14-7
E014
Pawl
Hub Cutout
PEOPLE/PEOPLE S 250
Driver Handle
Speedometer Gear Unit
Axle
Speedometer Gear Unit
Outer Driver
Tab
Groove