KYMCO People Service Manual page 234

19. SWITCHES/HORN/FUEL UNIT/THERMOSTATIC SWITCH
/TEMPERATURE GAUGE/INSTRUMENTS/LIGHTS
HORN INSPECTION
Remove the front cover. ( Ö 2-5)
Disconnect the horn wire couplers.
The horn is normal if it sounds when a 12V
battery is connected across the horn wire
terminals.
FUEL UNIT
FUEL UNIT INSPECTION
Remove the fuel unit.
Disconnect the fuel unit wire connectors.
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
Wire Terminals Upper
Y/W G 9.1 9.3:
Electric tester: YF-3501
FUEL METER INSPECTION
Connect the fuel unit wire connectors and
turn the ignition switch "ON".
Before performing the following test,
operate the turn signals to determine that
the battery circuit is normal.
Check the fuel meter for correct indication by
moving the fuel unit float up and down.
Float Position
Upper
Lower
Wire Terminals
Free
Apply
The fuel meter is normal if it operates as
above indicated. If not, check for loosely
tightened nuts, poorly connected terminals or
shorted wires.
19-5
Lower
95 96:
Display
Much (Full)
Less (Empty)
Display
From Much to Less
From Less to Much
PEOPLE/PEOPLE S 250
Horn
Fuel Unit
Fuel Full
Fuel Unit
Upper
Lower
Fuel Empty