KYMCO People Service Manual page 9

1. GENERAL INFORMATION
„ After clamping, check each wire to make
sure it is secure.
„ Do not squeeze wires against the weld or
its clamp.
„ After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.
„ When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
„ Route wire harnesses to avoid sharp edges
or corners. Avoid the projected ends of
bolts and screws.
„ Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.
No Contact
PEOPLE/PEOPLE S 250
„ Route harnesses so they are neither
pulled tight nor have excessive slack.
„ Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
„ When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
„ Do not break the sheath of wire.
„ If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.
„ When installing other parts, do not press or
squeeze the wires.
Do not press or
squeeze the wire
Do not pull
too tight
1-6