KYMCO People Service Manual page 154

12. COOLING SYSTEM
WATER PUMP SHAFT INSTALLATION
Drive a new water pump shaft outer bearing
into the water pump assembly from the
inside.
Install the water pump shaft and shaft inner
bearing into the waster pump assembly.
Install the snap ring to secure the inner
bearing properly.
Install the dowel pins and a new gasket and
then install the water pump assembly to the
right crankcase cover.
Tighten the eight bolts to secure the right
crankcase cover.
When installing the water pump
assembly, aligning the groove on the
water pump shaft with the tab on the oil
pump shaft.
PEOPLE/PEOPLE S 250
Outer Bearing
Water Pump Assembly
Snap Ring Water Pump Shaft
Inner Bearing
Bolts
Water Pump Assembly
12-12