Ricoh MP C6502 series Operation Manual page 1420

3. Installing the Scanner Driver
This chapter explains how to install the TWAIN driver on a client computer. Installing procedures on
Windows 7 is shown as an example except where indicated.
Installing the TWAIN Driver
To use the network TWAIN scanner, you must install the TWAIN driver on a client computer.
1. Quit all applications. (Do not close this manual.)
2. Insert the provided CD-ROM into the computer's CD-ROM drive.
If the [AutoPlay] dialog box appears, click [Run SETUP.EXE].
If you are using a computer that is running Windows 8 or Windows Server 2012, click the drive
and CD-ROM names when these appear in the upper right corner of the screen, and then click
[Run SETUP.EXE].
3. Select an interface language, and then click [OK].
For details about the languages supported in the TWAIN driver, see page 7 "TWAIN Driver".
4. Click [TWAIN Driver].
5. The installer of the TWAIN driver starts. Follow the instructions.
• The [Auto Play] dialog box is displayed only for a few seconds under Windows 8 and Windows
Server 2012. If the [AutoPlay] dialog box disappears, use the following procedure to replay the
CD-ROM:
1. On the Charm Bar, click [Search], and then click [Computer].
2. Double-click the CD-ROM drive in which the provided CD-ROM is set, and then click
"Setup.exe".
• Before you start the installation, check the system requirements for the TWAIN driver. For details
about the system requirements, see page 5 "Software and Utilities Included on the CD-ROM".
• When the installation is complete, a message about restarting the client computer may appear. In
this case, restart the client computer.
• After the installation is complete, a folder with the name of the machine in use is added in
[Programs] or [All Programs] on the [Start] menu. Help can be displayed from here.
• Notes on using the network TWAIN scanner are provided in "Readme.txt". Be sure to read them
before use.
43