Cabinet And Rack Installation; Figure 3-12: Rack/Cabinet Bracket Installation - IEI Technology AFL3-W07A-AL User Manual

AFL3-W07A-AL Panel PC

3.6.3 Cabinet and Rack Installation

The AFL3-W07A-AL flat bezel panel PC can be installed into a cabinet or rack. The
installation procedures are similar to the panel mounting installation. To do this, please
follow the steps below:
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL3-W07A-AL flat bezel panel PC and the
rack/cabinet into which the AFL3-W07A-AL is installed.
Step 1:
Slide the rear chassis of the AFL3-W07A-AL flat bezel panel PC through the
rack/cabinet bracket until the frame is flush against the front of the bracket
(Figure 3-12).

Figure 3-12: Rack/Cabinet Bracket Installation

Step 2: Insert a M5*50 screw into the screw hole on the side of the rack mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-13.
Sequence
1
Item Photo
Spring
Instruction
Install a spring onto the screw.
Page 25