Installation And Configuration Steps; Ssd Installation - IEI Technology AFL3-W07A-AL User Manual

AFL3-W07A-AL Panel PC
Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear an anti-static wristband.

3.3 Installation and Configuration Steps

The following installation steps must be followed.
Step 1: Unpack the flat bezel panel PC.
Step 2: Install an mSATA module.
Step 3:
Configure the system.
Step 4:
Connect peripheral devices to the flat bezel panel PC.
Step 5: Mount the flat bezel panel PC.
3.4 M.2 SSD Installation
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install an M.2 SSD into the AFL3-W07A-AL, please follow the steps below:
Step 1: Remove two (2) retention screws from the back cover (Figure 3-1).
Step 0:
Page 15