Procedure For Writing A Program - Mitsubishi 00JCPU User Manual

11.1.3 Procedure for writing a program

This section describes a procedure for writing a program to the program memory. (
Follow the procedure below and then the procedure provided in Section 11.1.4 before storing the program in the
standard ROM for boot operation.
In the following procedure,
NO
Change the number of device points in the
Device tab of the PLC parameter dialog box.
Create a program to be executed
NO
Set the initial device value range.
Set a file name for initial device value
in the PLC file tab of the PLC parameter
Connect the personal computer to which GX
Developer is installed to the CPU module.
Set the RUN/STOP/RESET switch to STOP
11 - 4
indicates an operation on the CPU module side.
Start
Start GX Developer.
Set the project.
Change the number
of device points?
YES
in the CPU module.
Use the initial
device value?
YES
Set the device memory.
dialog box.
and power on the CPU module
(the ERR. LED turns on).
1)
GX Developer Version 8 Operating Manual
GX Developer Version 8 Operating Manual
Ladder (writing) screen
Section 6.26
Section 6.26
Section 6.26
Section 5.1.2)