Mitsubishi 00JCPU User Manual page 143

(2) Data that can be stored in each memory
Table5.4 provides the data that can be stored in each memory.
Program
Item
memory
Drive 0
Parameter
Intelligent function module
2
parameter*
Program
Device comment
Initial device value
Device data
File register
Local device
Sampling trace file
Boot setting file
Remote password
Error history data
Programmable controller
user data
*11
Label program
User setting system area
*10
*1: A drive number is used to specify a memory to be written/read by the external device using a sequence program or MC protocol.
Since the memory name is used to specify the target memory by GX Developer, the drive number needs not to be considered.
*2: Store the intelligent function module parameters in the same drive with the parameters.
When they are stored in different drives, the intelligent function module parameters do not become valid.
*3: A program stored in the standard ROM cannot be executed.
Store the program to the program memory before execution.
*4: The device comments cannot be read by instructions in a sequence program.
*5: Reading from a sequence program requires several scans.
*6: Only each one of file register, one local device, and/or sampling trace file can be stored in the standard RAM.
*7: For the number of storable file register points, refer to Section 9.7.
*8: A sequence program allows reading only. No data can be written from the sequence program.
*9: Data can be written or read with the following instructions.
• SP.FREAD (batch-reads data from the specified file in the memory card.)
• SP.FWRITE (batch-writes data to the specified file in the memory card.)
*10: Set an area used by the system. (
*11: Data that stores the label program configuration.
For the label program, refer to the following.
GX Developer Version8 Operating Manual
Table5.4 Data that can be stored in each memory
CPU module built-in memory
Standard Standard
RAM ROM
Drive 3 Drive 4
*1 *1 *1
*3
*4 *5
*6*7
*6
*6
Section 5.2.2(2)(b))
CHAPTER5 MEMORIES AND FILES USED FOR CPU MODULE
Memory
Memory card
(ROM)
card (
RAM)
ATA
SRAM card Flash card
card
Drive 1 Drive 2
*1 *1
*3 *3
*5 *5
*8
File name and
Remarks
extension
PARAM.QPA 1 data/drive
IPARAM.QPA 1 data/drive
*3
***.QPG
*5
***.QCD
***.QDI
***.QST
***.QDR
1 data/CPU
***.QDL
module
***.QTD
AUTOEXEC.QBT
00000000.QTM
***.QFD
*9
***.CSV/BIN
PROJINFO.CAB
-
: Required, : Storable, : Not storable
5 - 14
1
2
3
4
5
-
-
6
-
-
-
7
-
-
8
-
-
-
-
-