Operating The Program In The Standard Rom And Memory Card (Boot Operation) - Mitsubishi 00JCPU User Manual

5.2.8 Operating the program in the standard ROM and memory card (boot
operation)
This section describes methods for operating the program stored in the standard ROM and memory card.
(1) Operating the program in the standard ROM and memory card
To execute the boot operation, set the names of files to be booted in the Boot file tab of the PLC parameter dialog
box. ( (3), (4) in this section)
The program stored in the standard ROM and memory card, whose file name is specified in the Boot file tab, is
booted with the program memory after the CPU module is powered off and then on or is reset.
(2) Bootable files, transfer source, and transfer destination
Table5.7 provides the combinations of bootable file, transfer source, and transfer destination.
Table5.7 Combinations of bootable file, transfer source, and transfer destination
File type
*1
Parameter
Sequence program
Device comment
Initial device value
*1: The intelligent function module parameter is included.
Boot
Program
Standard ROM
memory
Memory card
Figure 5.33 Boot operation
Transfer source
Standard ROM Memory card
CHAPTER5 MEMORIES AND FILES USED FOR CPU MODULE
Boot
CPU module
Transfer destination
Program memory
: Bootable, : Cannot be booted
5 - 34
1
2
3
4
5
6
7
8