Mitsubishi 00JCPU User Manual page 445

(2) File register setting
In a new device memory screen, set data for the specified file register.
(a) Devices
Setting R (R0 in the case shown above) and clicking the
n
(b) Data setting
Enter data that are set for the file register.
This step is not needed when you specify only the capacity of file register.
(3) Registering the file register file to the CPU module
When either of the following is selected in the PLC file tab of the PLC parameter dialog box, the file register must
be set (a device memory must be create) before the file register file is registered to the CPU module.
• Not used. (When specifying a file register used in the sequence program) (
• Use the same name with the program. (
A file register file can be registered to the CPU module using GX Developer.
Figure 9.77 Device memory screen
Display
(1)(b) in this section)
CHAPTER9 DEVICES
button will display the file register list.
(1)(a) in this section)
9
9 - 70