Registration Procedure For The File Register - Mitsubishi 00JCPU User Manual

9.7.4 Registration procedure for the file register

To use a file register, register the file of the file register to the CPU module in the following
When the file is stored in the
standard RAM or SRAM card:
Write to PLC screen
Note10
Note9.10
Basic
For the Basic model QCPU, this procedure is not required because the file register is automatically registered to the
standard RAM.
9 - 67
Start
Setting a file register file
File register setting
Writing a file register file
Write the file register file to the CPU module
Write parameters to the CPU module
Figure 9.74 Registration procedure for the file register
Note9.10
When "Use the following file." is selected
When "Not used" or
"Use the same file names as the program."
is selected
When the file is stored in the Flash card:
Write to PLC (Flash ROM) screen
steps.Note10
PLC file tab of the
PLC parameter dialog box
Device memory screen