Mitsubishi 00JCPU User Manual page 247

Remark
When the POFF instruction is executed, a non-execution processing is performed for one scan. The number of execution
times displayed is the addition of the execution times of the non-execution processing.
For details of the POFF instruction, refer to the following.
MELSEC-Q/L Programming Manual (Common Instruction)
(3) Program start
Clicking the
Startup
program screen.
(a) Program name
Select a program set in the Program tab of the PLC parameter dialog box.
A program name cannot be entered as desired.
(b) Startup mode
Set any of the following programs as a start-up program for a stand-by type program.
• "Scan execution": Scan execution type program
• "Low speed execution": Low-speed execution type program
• "Fixed scan execution": Fixed scan execution type program
The value set in the Program tab of the PLC parameter dialog box is displayed as the default value of fixed
scan execution type program.
The unit can be selected from ms or s.
Note14
Note6.11
Basic
The Basic model QCPU does not support program start from the Program monitor list screen.
Note6.12
Redundant
Since the Redundant CPU does not support the use of low-speed execution type programs, "Low speed execution"
cannot be selected in "Startup mode".
Note14
Note6.11
button on the screen shown in Figure 6.49 (
(a)
(b)
Figure 6.50 Startup program screen
CHAPTER6 FUNCTIONS
(2) in this section) opens the Startup
Note6.12
1
2
3
4
5
6
7
8
6 - 67