Mitsubishi 00JCPU User Manual page 280

Diagnostics
message
Both systems
file
consistency
error
CPU MODE
Parameter- DIFF.
valid drive
consistency
error
Tracking data
TRK.TRAN
communicati
S. ERR.
on error
Tracking
TRK.SIZE
capacity
ERROR
excess error
Tracking
cable error or
tracking TRK.CABL
transfer E ERR.
hardware
failure
Tracking
cable not
connected,
TRK.
failure, or
DISCON-
tracking
NECT
transfer
hardware
failure
Redun-
dant sys-
Tracking
TRK.INIT.
tem error
transfer initial
ERROR
error
System
switching
from standby
CONTROL
system to
EXE.
control
*6
system
System
switching
from control
STANDBY
system to
standby
*6
system
System
CAN'T
switching
SWITCH
error
Standby
system not STANDBY
started or SYS.DOWN
stop error
Control
system not CONTROL
started or SYS.DOWN
stop error
Program PRG.MEM.
memory clear CLEAR
6 - 100
Table6.27 Self-diagnostics list (continued)
Error
Diagnostic timing
• Power-on/reset
• Execution of the END
instruction
• Mounting of tracking
cable
• Always
• Execution of the END
instruction
• Power-on/reset
• Always
• Power-on/reset
• Always
• Always
• System switching
• Always
• Always
• Execution of the program
memory copy function
CPU LED status Basic
module model
RUN ERR.
status QCPU
Stop Off Flashing
Continue On On
Continue On On
Stop Off Flashing
Continue On On
Stop Off Flashing
Continue On Off
Continue On Off
Continue On On
Continue On On
Stop Off Flashing
Stop Off Flashing
: Self-diagnostics is performed,
High
Process Redundant
Performance
CPU CPU
model QCPU
: Self-diagnostics is not performed
(To the next page)