Mitsubishi 00JCPU User Manual page 219

6.11.1 Monitor condition setting
This function is used to monitor data in the CPU module under the specified
(1) Monitor condition setting for ladder monitor
Switch GX Developer into monitor mode.
Select [Online]
Set the condition as shown below to monitor data on the rising edge of Y70.
Select to use a device as
a monitor condition.
Select to use a step
number as a monitor
condition.
Monitoring starts
when the condition is
established.
(An operation status
when the condition
is established is
displayed.)
Note7
Note6.3
Basic
The Basic model QCPU cannnot perform monitor operation under the specified condition.
Note6.3
[Monitor] [Monitor condition setup] to open the Monitor condition screen.
Figure 6.27 Monitor condition setting screen
CHAPTER6 FUNCTIONS
condition.Note7
1
2
3
4
5
6
7
8
6 - 39