Konica Minolta bizhub C353 Service Manual page 416

Field Service Ver. 4.0 Jun. 2008
Step
Using the telephone
line modem
Inputting the AT com-
mand for initializing the
modem
1. Select [Service
Mode] → [CS
Remote Care] →
and touch [Detail
Setting].
2. Touch [AT Com-
mand].
3. Input AT Command.
11
NOTE
• Change this com-
mand only when it
is necessary.
(They do not need
to be changed in
normal condition.)
• For details on AT
command, see the
manual for the
modem.
See P.381
Setting the DIPSW for CS Remote Care
NOTE
12
• This setting is not normally necessary.
Take this step only when necessary in a
specific connecting condition.
Executing the initial transmission
1. Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2. Touch [initial transmission] key on the right
bottom of the screen to start initial transmis-
sion.
3. When the machine is properly connected
with the center, CS Remote Care setting
screen will be displayed.
NOTE
• The initial transmission key at the right
bottom of the screen will be displayed
13
only when the center ID, the device ID,
Telephone number of the center and the
device telephone number have been
input.
See P.379
Procedure
Using the Fax line
modem *1
Proceed to step 12. Setting the E-mail address
1. Select [Service Mode] → [CS Remote Care],
2. Touch [Server for RX], and set POP3 server
See P.381
3. Press [Receive], and set the E-Mail address,
See P.381
4. Touch [Send], and set the SMTP server
See P.381
5. Touch [TX/RX Test], and press Start key to
See P.381
Proceed to step 13.
Receiving the initial connection E-mail mes-
sage
Sending the initial connection E-mail message
from the center to the address of the copier.
NOTE
• When receiving the initial connection E-
• For sending the initial connection E-mail,
• Messages can be exchanged only
• The initial connection from the center will
• When the initial registration is complete,
10. Service Mode
Using E-mail
and touch [Server Set].
address, POP3 login name, POP3 password
and POP3 port number.
Mail Check, Connection Time Out and
APOP Authentication.
address, SMTP port number, Connection
Time Out, and APOP Authentication.
carry out a transmission/reception test. If it
fails to exchange messages, see the error
message to take necessary measure, and
try again.
mail message from the center while CS
Remote Care-related screen is being dis-
played, the current setting information
will be deleted, and CS Remote Care set-
ting will be displayed.
see the manual for CS Remote Care cen-
ter.
between the center with initial connection
and the copier.
be carried out, and the E-mail address of
the center will be stored in the copier.
the E-mail address of the center will be
displayed by selecting [Service Mode] →
[CS Remote Care] → [Detail Setting],
[Basic Setting] → [E-Mail address].
371