Procedure After Replacing The Eep-Rom (Ic1002); Punch Center Position Adjustment - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 2.0 Jan. 2008
7.2.3

Procedure after replacing the EEP-ROM (IC1002)

1. Turn OFF the main power switch of the main body.
ON
1
7.2.4

Punch center position adjustment

• This adjustment is made when the punch lateral movement is changed from the lateral
registration motion (automatic through end face detection) to fixed system based on the
paper size.
1. Turn main power switch OFF, and remove the finisher from the machine.
2. Remove the rear cover from the finisher.
See P.8
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
2 3 4
4583fs3517c0
5 6 7 8
4583fs3523c0
5 6 7 8
4583fs3524c0
5 6 7 8
4583fs3525c0
2. Set the bits 1 through 4 of
DIPSW1001 on the punch control
board as shown on the left figure.
3. Press SW1002 and SW1003 on the
punch control board simultaneously.
• This will initialize the EEP-ROM. After
the initialization, all LED1001,
LED1002 and LED1003 light up.
4. Adjust the sensor output, and regis-
ter the number of punch holes.
5. Set all bits of DIP SW 1001 to OFF.
3. Check that all keys of SW1 of the fin-
isher control board are OFF.
4. Turn ON the main power switch of
the main body and wait until the fin-
isher completes its initial operation.
• Use the following procedure to clear
the adjustment of the punch lateral
movement.
5. Turn ON keys 4, 5, 6, and 7 of SW1
of the finisher control board.
6. Turn ON key 1 of SW1 of the finisher
control board.
7. Press PSW1 and PSW2 of the
finisher control board at the same
time.
7. Board switch
59