Konica Minolta bizhub C353 Service Manual page 367

8. Utility Mode
(2) Prohibited Functions When Authentication Error
Functions • To set the function for prohibiting authentication operation in order to prevent the
unauthorized access.
Use • To use when setting the system to prohibit authentication failure when conducting
authentication by password, etc.
• Authentications which are subjected to this function: CE authentication, administrator
authentication, user+ accounts authentication, SNMP authentication, secure print
authentication, user box authentication.
Mode 1 : When failed to authenticate, authentication operation (entering the pass-
Mode 2 : When failed to authenticate, authentication operation (entering the pass-
user+ accounts
authentication
SNMP authentication
secure print authenti-
cation
user box authentication
Administrator authenti-
cation
CE authentication
Setting/ • The default setting is Mode 1.
Procedure
NOTE
• [Mode1] cannot be selected when the following setting is set to "ON."
[Administrator Settings] → [Security Setting] → [Enhanced Security Mode]
• Only the number of times for trials up to the access lock can be changed.
• When [Mode 2] is selected, set the number of times where checks are made before
access is locked.
• Touch [Release Time Settings] and set a period of time that elapses before access
lock is released.
322
word) will be prohibited for a certain period of time.
word) will be prohibited for a certain period of time.
The number of times failure occurred will be counted, and when the
number reaches to the specified time, authentication will be prohibited
and the access will be locked.
When the access is locked, touch [Release] on the main body, or turn
main power switch OFF/ON to cancel it.
For CE authentication and administrator authentication, only turning
main power switch OFF/ON will cancel it.
When the machine goes into an access lock condition, release the lock
in the following procedure.
• Touch keys in the following order. [Administrator Settings]
→ [Security Setting] → [Security Details] → [Prohibited
Functions When Authentication Error].
Then touch [Release].
• After the main power switch is turned OFF and ON, the
access lock is released automatically after the lapse of a
predetermined period of time.
• [Service Mode] → [Enhanced Security] → [Administrator
unlocking]
• The lock release timer starts to operate by input the Stop
→ 0 → 9 → 3 → 1 → 7 in [Meter Count] → [Check Details]
→ [Coverage Rate] after the main power switch is turned
OFF and On. When the timer reaches the time specified in
this setting, the access lock is released.
"Mode 1"
Field Service Ver. 4.0 Jun. 2008
Mode 2