Adjustment Procedure; Saddle Gear Phase Adjustment - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 2.0 Jan. 2008
6.4

Saddle gear phase adjustment

• Whenever the gear in front of the saddle or the folding roller has been replaced or
removed for some reason, make gear phase adjustment following the procedures given
below.
6.4.1

Adjustment procedure

1. Remove the saddle.
See P.14
[1]
2. Remove five screws [1], and
[2]
[1]
A0D6F3C526DA
3. Set the folding roller [1] and saddle
[2]
4. With the folding roller and the saddle
[1]
A0D6F3C527DA
NOTE
• The mark on the saddle cam drive
[1]
gear [1] (either of the two marks)
comes face to face with the mark on
the middle gear [2] (the mark on the
semi spherical part with narrow
[2]
gear face width).
5. With the saddle cam drive gear [1]
[3]
A0D6F3C528DA
6. Mechanical adjustment
remove the saddle gear cover [2].
cam [2] within the saddle as shown
in the figure.
cam positioned as shown in the left
figure, set the gears as shown in the
figure in the following way.
and the middle gear [2] positioned as
above, the mark on the middle gear
[2] (the mark on the other semi
spherical part) meets face to face
with the rib of the folding roller drive
gear [3].
51