Konica Minolta bizhub C353 Service Manual page 792

Field Service Ver. 2.0 Jan. 2008
5. Call the Service Mode to the screen.
See P.338 of the main body service manual.
6. Touch [ADF].
7. Touch [Original Stop Position].
10. Touch [END].
11. Touch [Exit] on the Service Mode screen.
12. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
13. Make a copy of the chart again and check that the difference in the widths of b falls
within the specified range.
8. Touch [Main Scanning Direction].
9. Enter the value from the ten-key pad.
• Adjustable range: -3.0 mm to + 3.0
mm
• If the difference in the widths of b is
greater than the specifications, enter
the + value.
• If the difference in the widths of b is
smaller than the specifications, enter
the - value.
A01HF3E532DA
7. Mechanical adjustment
(Press the [+/-] key to change the +/-
code.)
(in 1-mm increments)
A01HF3E525DA
43