Konica Minolta bizhub C353 Service Manual page 335

8. Utility Mode
H. SNMP Setting
(1) SNMP Setting
Functions • To set whether to use SNMP (Simple Network Management Protocol) or not.
• To set the SNMP version to be used.
Use • Not to use SNMP.
• To readout management information base and to enter community name for writing.
Setting/ • The default setting is ON.
Procedure
• To individually set whether or not to use SNMP v1/v2c (IP), SNMP v3 (IP), and
SNMP v1 (IPX).
• The default setting is ON.
(2) UDP Port Number
Functions
• To set the UDP standby port number which is used for SNMP (IP).
Use
Setting/ 1. Touch the Clear key.
Procedure 2. Enter the port number between 1 and 65535 using the 10-key pad.
(3) SNMP v1/v2c Settings
Functions • To conduct setting when using SNMP v1/v2c.
Use • To use when changing write setting.
• To use when entering the community name for reading the Management Information
Base (MIB) and writing to it.
Setting/ <Read Community Name Settings>
Procedure • Enter a Read community name.
<Write Setting>
• The default setting is Enable.
NOTE
• [Enable] cannot be selected when the following setting is set to "ON."
[Administrator Settings] → [Security Setting] → [Enhanced Security Mode]
<Write Community Name Settings>
• Enter a Write community name.
(4) SNMP v3 Settings
<Context Name Settings>
Functions
• Set the context name which is used for SNMP v3.
Use
Setting/ 1. Touch [Name].
Procedure 2. Enter the context name (up to 64 characters) on the on-screen keyboard, and touch
[OK].
290
"ON"
"ON"
"Enable"
Field Service Ver. 4.0 Jun. 2008
OFF
OFF
Disable