Chapter 4
Configuring Settings on the Cisco Unified IP Phone
Power Save Configuration Menu
The Power Save Configuration menu displays the settings that control when the phone screen backlight
turns off to conserve power.
For detailed information about configuring these settings, see
Unified IP Phone Backlight, page
Table 4-16
Power Save Configuration Menu Options
Option
Description
Backlight
Time each day that the backlight on automatically
On Time
(except on the days specified in the Days Display Not
Active field).
Backlight
Length of time that the backlight remains on after turning
On Duration
on at the time shown in the Display On Time option.
Backlight
Length of time that the phone is idle before the display
Idle Timeout
turns off. Applies only when the display was off as
scheduled and was turned on by an end-user (by pressing
a button on the phone or lifting the handset).
Days Backlight
Days that the display does not turn on automatically at
Not Active
the time specified in the Display On Time option.
Backlight On If
Indicates whether the backlight automatically illuminates
Incoming Call
when a call is received.
Ethernet Configuration Menu
The Ethernet Configuration menu includes the options described in
Table 4-17
Ethernet Configuration Menu Options
Option
Description
Forwarding
Indicates whether the internal switch begins forwarding
Delay
packets between the PC port and switched port on the phone
when the phone becomes active.
•
When forwarding delay is set to disabled, the internal
switch begins forwarding packets immediately.
•
When forwarding delay is set to enabled, the internal
switch waits 8 seconds before forwarding packets between
the PC port and the switch port.
Default is disabled.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
OL-20798-01
Table 4-16
describes the options on this menu.
6-5.
Device Configuration Menu
Automatically Disabling the Cisco
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
Table 4-17
To Change
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
4-29