Cisco 7931G Administration Manual page 71

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-3 IPv4 Configuration Menu Options
Option Description
DHCP Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns
the phone anIPv4 address. When DHCP is
disabled, the administrator must manually assign
an IPv4 address to the phone.
IP Address Internet Protocol version 4 (IPv4) address of the
phone.
If you assign an IPv4 address with this option, you
must also assign a subnet mask and default router.
See the Subnet Mask and Default Router options
in this table.
Subnet Mask Subnet mask used by the phone.
Default Router 1 Default router (Default Router 1) and optional
backup routers (Default Router 2–5) used by the
Default Router 2
phone.
Default Router 3
Default Router 4
Default Router 5
DNS Server 1 Primary DNS server (DNS Server 1) and optional
backup DNS servers (DNS Server 2–5) used by
DNS Server 2
the phone.
DNS Server 3
DNS Server 4
DNS Server 5
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
OL-20798-01
Network Configuration Menu
To Change
Unlock network configuration options.
1.
2. Scroll to the DHCP option and press the No
softkey to disable DHCP, or press the Yes
softkey to enable DHCP.
Press the Save softkey.
3.
Unlock network configuration options.
1.
Set the DHCP option to No.
2.
Scroll to the IP Address option, press the Edit
3.
softkey, and then enter a new IP Address.
Press the Validate softkey and then press the
4.
Save softkey.
1. Unlock network configuration options.
Set the DHCP option to No.
2.
Scroll to the Subnet Mask option, press the
3.
Edit softkey, and then enter a new subnet
mask.
4. Press the Validate softkey and then press the
Save softkey.
Unlock network configuration options.
1.
2. Set the DHCP option to No.
Scroll to the appropriate Default Router
3.
option, press the Edit softkey, and then enter a
new router IP address.
4. Press the Validate softkey.
5. Repeat Steps 3 and 4 as needed to assign
backup routers.
Press the Save softkey.
6.
1. Unlock network configuration options.
Set the DHCP option to No.
2.
Scroll to the appropriate DNS Server option,
3.
press the Edit softkey, and then enter a new
DNS server IP address.
Press the Validate softkey.
4.
5. Repeat Steps 3 and 4 as needed to assign
backup DNS servers.
6. Press the Save softkey.
4-9