Cisco 7931G Administration Manual page 90

Device Configuration Menu
Table 4-15 Media Configuration Menu Options (continued)
Option Description
Recording Tone Indicates the length of time in milliseconds that the
Duration beep tone plays. If the value that you configure here is
less than one third of the interval, this value overrides
the default value that is provided by the Network
Locale.
Range: 0 to 3000
Note
See also
Wideband Indicates whether wideband is enabled or disabled for
Headset the headset.
Default: Disabled
Enterprise Enables/disables (enabled by default) Cisco Unified IP
Advertise G.722 Phones to advertise the G.722 codec to the Cisco
Unified Communications Manager. For more
information, see the Cisco Unified Communications
Manager System Guide,
Note
Device Allows you to override the Enterprise Advertise G.722
Advertise G.722 Codec on a per-phone basis.
The default is "Use System Default," which means that
the value configured for the Enterprise G.722 Codec
parameter is used.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
4-28
For some Network Locales that use a complex
cadence, this setting applies only to the first
beep tone.
Recording Tone in this table.
Cisco Unified IP
When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is Disabled.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
• If Wideband Headset UI Control is enabled,
you or the user can set this value from the
Settings menu on the phone by choosing
User Preferences > Audio Preferences >
Wideband Headset.
If Wideband Headset UI Control is disabled,
•
from Cisco Unified Communications
Manager Administration, choose Device >
Phone > Phone Configuration to set
this value.
If you allowed this option to be user
Note
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
Phones.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
OL-20798-01