Appendix E
Basic Phone Administration Steps
Adding a User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications
Manager Administration by following these steps:
Procedure
Choose User Management > End User, then click Add New. The End User Configuration
Step 1
window appears.
In the User Information pane of this window, enter the following:
Step 2
•
•
•
•
Step 3
Click Save.
Proceed to
Step 4
Configuring the Phone
First, perform the following procedure to identify the user's phone model and protocol:
Procedure To Select Phone Model and Protocol
From Cisco Unified Communications Manager administration, choose Device > Phone >.
Step 1
Click Add New.
Step 2
Select the user's phone model from the Phone Type drop-down list, then click Next.
Step 3
Select the device protocol (SCCP or SIP) from the drop-down list, then click Next. The Phone
Step 4
Configuration window appears.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
OL-20798-01
User ID—Enter the end user identification name. Cisco Unified Communications Manager does not
permit modifying the user ID after it is created. You may use the following special characters: =, +,
<, >, #, ;, \, , "", and blank spaces.
Example: johndoe
Password and Confirm Password—Enter five or more alphanumeric or special characters for the end
user password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank
spaces.
Last Name—Enter the end user last name. You may use the following special characters: =, +, <, >,
#, ;, \, , "", and blank spaces.
Example: doe
Telephone Number—Enter the primary directory number for the end user. End users can have
multiple lines on their phones.
Example: 26640 (John Doe's internal company telephone number)
Configuring the Phone, page
E-3.
Configuring the Phone
E-3