Adjust Tilt And Level The Cinema Projector - Christie CP2210 User Manual

Section 2: Installation and Setup
forfeit some aim and stay more parallel to the screen. In such cases, some lens offset can reduce the key-
stone distortion.
3. Once you have completed the remaining installation steps and the cinema projector is up-and-running,
adjust precise image geometry and placement, as described in
2.3

Adjust Tilt and Level the Cinema Projector

WARNING
the cinema projector's baseplate.
The lens should be centered and parallel with the screen to ensure optimum lens performance with minimal
offset. If this position is not possible, it is better to rely on offset rather than extra tilt.
Use a protractor to measure the degree of screen tilt and then extend or retract the cinema projector feet to
match this angle.
NOTICE: The front-to-back tilt of the cinema projector must not exceed 15°. This limit ensures safe lamp
operation and the proper positioning of the liquid cooling reservoir.
To adjust the vertical or horizontal position of the cinema projector, extend or retract the adjustable feet on the
bottom of the cinema projector by rotating them. Once the required adjustment is made, tighten the lock nut.
2-4
DO NOT
over-extend the feet. Make sure several threads are engaged into
Disconnect from AC for these alignments. Images are not yet needed.
4.3 Basic Image Alignment.
020-100410-08 Rev. 1 (05-2014)
CP2210 User Manual