Connecting Devices To The 3D Connector - Christie CP2210 User Manual

3.5

Connecting Devices to the 3D Connector

The 3D connector is a 15-pin D-sub connector (female) located on the PIB input panel. This table lists the
control functions available through the 3D connector.
PIN SIGNAL NAME
1 +12V
2 GND
3 GND
4 RS232_RX
5 RS232_TX
6 CONN_3D_MODE+
7 CONN_SYNC+
8 3D_INPUT_REFRERENCE+
9 +12V
10 3D_INPUT_REFRERENCE-
11 3D_DISPLAY_REFERENCE+
12 3D_DISPLAY_REFERENCE-
13 CONN_3D_MODE-
14 CONN_SYNC-
15 Not connected
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
Section 3: Connecting Devices to the Projector
DIRECTION DESCRIPTION
Out Power to 3D device. Maximum 1A (total between both
+12V pins).
/ Ground
/ Ground
In Data to cinema projector from 3D device. 1200 Baud, 8
bits, no parity. Currently unsupported.
Out Data to cinema projector from 3D device. 1200 Baud, 8
bits, no parity. Currently unsupported.
Out SYNC from cinema projector. To cinema projector
GPO collector. Compatible with current cinema projec-
tor GPIO requirements and restrictions. (24VDC max,
50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from cinema projector. To cinema projector
GPO collector. Compatible with current cinema projec-
tor GPIO requirements and restrictions. (24VDC max,
50mA max)
In 3D L/R Input Reference (P)
(Voltage Limit: 1.4VDC to 12VDC)
Out Power to 3D system. Maximum 1A (Total between both
+12V pins)
In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
Out 3D mode state from cinema projector. From cinema
projector GPO emitter. Compatible with current cinema
projector GPIO requirements and restrictions. (24VDC
max, 50mA max)
Out SYNC from cinema projector. From cinema projector
GPO emitter. Compatible with current cinema projector
GPIO requirements and restrictions. (24DC max, 50mA
max)
3-5