5 Operation
This section describes how to operate the CP2210 cinema projector.
5.1
Turn the Cinema Projector On
WARNING
within the specified voltage range.
1. Ensure the circuit breaker for the cinema projector is ON.
2. On the Touch Panel Controller (TPC), tap and hold the green power
3. On the TPC, tap and hold the light bulb
5.2
Turn the Cinema Projector Off
1. On the Touch Panel Controller (TPC), tap and hold the light bulb
2. On the TPC, tap and hold the red power
the fans and electronics stay on for 10 minutes. After this cool down period, the cinema projector enters
standby mode.
3. If you are servicing the cinema projector, or removing the protective cover, disconnect AC and turn the
breaker OFF.
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
DO NOT attempt to turn the cinema projector on if the AC supply is not
icon to ignite the lamp.
icon. The cinema projector enters a cool down mode and
icon.
icon to turn the lamp off.
5-1