Install The Touch Panel Controller; Connect Optional Exhaust Ducting - Christie CP2210 User Manual

2.4

Install the Touch Panel Controller

1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the cinema
projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the cinema projector.
4. Adjust the angle of the TPC.
2.5

Connect Optional Exhaust Ducting

If the room the cinema projector is installed in is not equipped to ventilate up to 11,000 BTU (per hour) you
must install the optional duct (P/N: 119-103105-xx).
Connect the pre-existing external venting ductwork to the optional duct on the side of the cinema projector.
Confirm that there are no obstructions or bends in the ducting, and all air intakes are free of obstructions.
The pre-installed outside-venting duct
should be rigid at the cinema projector and
must also include a heat extractor and blower
that maintains a minimum of 450 CFM*
when the cinema projector is operating at
less than or equal to 25°C ambient and less
than 3,000 feet, when measured at the
cinema projector exhaust opening.
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
Section 2: Installation and Setup
2-5