Position The Cinema Projector - Christie CP2210 User Manual

• OFF: Not detected.
• Red: Detected communication problems etc.
• Green: Detected and working properly.
ICP Faceplate Connections
The ICP board provides the image processing electronics for the cinema projector. The ICP faceplate includes
a number of LEDs that are only functional when the cinema projector is in full power mode.
• REGEN: (Regulators Enabled) Indicates the presence of the internal regulator enable signal. When illumi-
nated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) Indicates the state of the software application. When OFF, in a Fail state (0).
When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) Indicates the state of the operating system. When OFF, in a Fail state (0).
When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) Indicates the configured state of the FMT FPGA. When RED, unable to con-
figure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
• ICPST: (ICP FPGA State) Indicates the configured state of the ICP FPGA. When RED, unable to configure
FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main applica-
tion.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.
Touch Panel Controller (TPC)
The TPC is a touch-sensitive screen that you use to control and monitor the status of the cinema projector. It is
mounted on the rear of the cinema projector and you can use the flexible connection to adjust the viewing
angle.
You can install the TPC on a wall near the cinema projector, or you can use the optional extension cable to
control the cinema projector from a maximum distance of 100 feet.
2.2

Position the Cinema Projector

WARNING
new lamp in the cinema projector.
1. If you are installing the cinema projector in the optional rack stand (P/N 108-282101-xx) follow the
instructions provided with the rack stand to install it.
NOTES: 1) For better access, wire the LPS before installing it into the rack stand. 2) Use the hold down
clamp (P/N 116-100101-01) when securing the cinema projector to the rack stand.
2. Position the cinema projector at an appropriate throw distance (cinema projector-to-screen distance) and
vertical position. Ideally, center the cinema projector with the theatre screen. If space is limited, you can
aim the cinema projector slightly off-center. This increases side keystoning, but reduces the horizontal lens
offset required.
NOTE: Keep the cinema projector lens as parallel to the screen as possible, even if significantly above the
screen center. When a particularly short throw distance combines with a very wide screen, you may have to
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
2 people are required to safely lift and install the cinema projector.
Perform a automatic LampLOC™ adjustment when you move, level, or install a
Section 2: Installation and Setup
2-3