Section 2: Installation and Setup
4. Remove the 4 screws securing the side skin to the top of the cinema projector structure.
5. Remove the 3 screws securing the side skin to the bottom of the cinema projector structure. Lift the skin
upward and out to remove it.
6. Pull one end of the protected earth wire through the rear side skin louvers.
7. Connect the protected earth wire to the cinema projector:
a. Loosen the threaded bolt on the ground lug (A).
b. Remove 15 mm of the insulated covering from the end of the protected earth wire.
2-10
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)