Replace The Air Filter - Christie CP2210 User Manual

7.10 Replace the Air Filter

projector without the filter installed. Always discard used air filters.
You should check the condition of the light engine air filter monthly. Replace the light engine air filter when
you replace the lamp module or sooner if you are operating the cinema projector in a dusty or dirty
environment. The filter is located on the right side of the cinema projector behind the air filter cover.
1. Loosen the 2 captive screws on the bottom of the
filter cover. (Figure 7-4)
2. Pull the cover out and down.
3. Slide the air filter out and discard. Insert the new
air filter with the airflow indicator facing toward
the cinema projector. NOTE: Never reuse an old
air filter. The air filters in this product cannot be
cleaned thoroughly enough for reuse and can lead
to the contamination of optical components.
4. Install the air filter cover by inserting the 2 bottom
tabs and then snapping the door closed.
5. Tighten the 2 captive screws.
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
Use only high efficiency Christie approved filters. Never operate the cinema
Figure 7-4 Remove Light Engine Air Filter
Section 7: Maintenance
7-7