Power Warnings; Power Cords And Attachments; Lamp Precautions - Christie CP2210 User Manual

Section 1: Introduction
1.3

Power Warnings

WARNING
• Use only the AC power cord supplied. DO NOT attempt operation if the AC supply is not
within the specified voltage and power range. For details, refer to Section 6 Specifications.
• As a safety feature the cinema projector is equipped with a three-wire plug with a third
(grounding) pin. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. DO NOT defeat the safety purpose of the grounding-type plug.
• DO NOT attempt operation if the AC supply is not within the rated voltage range, as speci-
fied on the license label.
• Disconnect cinema projector from AC before opening any enclosure.
• DO NOT allow anything to rest on the power cord. Locate the cinema projector where the
cord cannot be damaged by persons walking on it or objects rolling over it. Never operate
the cinema projector if the power cable appears damaged.
• DO NOT overload power outlets and extension cords as this can result in fire or shock haz-
ards.
• Only qualified service technicians are permitted to open any enclosure on the product and
only if the AC has been fully disconnected from the product.

1.3.1 Power Cords and Attachments

WARNING
Ensure that you are using a line cord, socket and power plug that meets the appropriate local
rating standards. Use only an AC power cord recommended by Christie. DO NOT attempt
operation if the AC supply and cord are not within the specified voltage and power range.
To avoid the risk of fire, shock, or personal injury, use only the attachments and accessories recommended by
Christie.
1.4

Lamp Precautions

Lamps used in the cinema projector are under high pressure and you must handle them with caution. Lamps
can explode and cause serious personal injury if they are dropped or mishandled.
DANGER
the lamp door is open!
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield, protective
gloves, and a quilted ballistic nylon jacket or a welder's jacket. This equipment is included in included in the
Christie Protective Clothing Safety Kit #598900-095.
DANGER
clothing whenever the lamp door is open or while handling the lamp. 2) Ensure those within
the vicinity of the cinema projector are also equipped with protective clothing. 3) Never
attempt to access the lamp while the lamp is on. Wait a minimum of 10 minutes after the lamp
turns OFF turning the cinema projector off, disconnecting it from a power source, and
opening the lamp door.
1-2
The North American rated line cord is provided with each cinema projector.
EXPLOSION HAZARD! Wear authorized protective safety clothing whenever
Lamp may explode causing bodily harm or death. 1) Always wear protective
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)