Config 2 Window - Christie CP2230 User Manual

Cinema Projector Menus
6.13.2

Config 2 Window

Use the Config 2 window to change the color settings of a channel.
Table 6.9 Channel Setup: Config 2 Window
Control
1: Measured Color
2: Target Color*
3: Color Space*
4: Gamma*
5: LUT_CLUT*
6: Scan Type
7: Automatic Scan
Type Detection
8: LD Bypass
6: Pull Down
Sequence
7: Pull Down Offset
8: SMPTE Field Bit
9: Re-Sync
* NOTE: Components marked with an asterisk (*) are part of pre-defined PCFs (cinema projector Configura-
tion Files) that control image processing for a given source. When you select Use PCF, these options are not
available.
6-20
1
2
3
4
5
Figure 6-13 Channel Setup: Config 2 Window
Description
The Measured Color Gamut Data (MCGD) file to use as a reference for calculating target color
processing.
The Target Color Gamut Data (TCGD) value.
The method of color decoding for the current source. The default is YCbCr for all DVI sources. The
default for all cinema sources is Unity RGB.
The gamma correction required for the proper tonal range of the source material.
Applies a 3D color cube for increased color accuracy.
The video scan type. The default is Progressive.
Automatically performs scan type detection. This feature is supported for PIB inputs only.
Bypasses the link decrypter. Select this option only if Marriage is broken and the content being displayed
is not CineLink 2 encrypted.
Applies the pull down sequence, which is typically a 2:2 Pull Down sequence. Pull down is used to
distribute file content to video. Since film is projected at 24 frames per second and video typically at 60
pictures per second, the film content must be converted to video for optimal display.
Identifies and sets the frame offset from fields 1 to 5.
Sets the field offset polarity.
This command is used to enable or disable the re-synchronization function associated with the Pull-Down
Sequence.
6
7
8
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)