Install The Primary Lens; Install The Optional Anamorphic Lens - Christie CP2230 User Manual

Installation and Setup
2.9

Install the Primary Lens

The lens seals the projection head, preventing contaminants from entering the main electronics area. Do not
operate the cinema projector without a lens installed. Install a lens plug when you install or transport the
cinema projector.
1. Verify the rear safety strap or rear hold down bracket is installed.
2. Rotate the lens clamp to the open position.
3. With the UP label facing up, insert the lens straight into the lens mount opening all the way back, without
turning.
4. Move the lens clamp to the down position to lock the lens assembly.
5. Remove the front lens cap.
6. On the TPC, tap Menu > Configuration > Diagnostics and Calibration.
7. Tap Reference Calibration.

2.10 Install the Optional Anamorphic Lens

1. Optimize your primary lens first for best optical alignment, offset and boresight
2. Install the auxiliary lens mount using the instructions included with the kit.
3. Loosen the holding clamp on the auxiliary lens mount. Adjust the rotation of the anamorphic lens so the
image remains perfectly square with anamorphic in and out.
2-10
1.
Install Lens
2.
Lock
Clamp
Open
Clamp
Locked
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)