Christie CP2230 User Manual page 151

Electronic Digital Convergence (EDC) (Continued)
BLUV
Set or query the blue vertical EDC value.
RSET
Set all six EDC values to their default value.
EXAMPLES:
(EDC?) Get all six EDC values
(EDC 0 3 1 2 2 3) Set all six EDC values at once. Set red horizontal to 0, green horizontal to 3, blue horizontal to 1, red vertical
to 2, green vertical to 2 and blue vertical to 3.
(EDC+REDH?) Set the red horizontal EDC value
(EDC+REDH 2) Set the red horizontal EDC value to 2
(EDC+BLUV?) Get the blue vertical EDC value
(EDC+BLUV 1) Set the blue vertical EDC value to 1
(EDC+RSET) Set all six EDC values to their default value
Enable Error Messages (EME)
Enable broadcasting error messages.
SUBCODE DESCRIPTION OF USE
FANF
0 - No Fan Fail warning will be generated,
1 - Fan Fail warning will be generated.
NONE
0 - Disable broadcast,
1 - Enable broadcast of error messages to all connected serial ports and telenet sessions.
TEMP
0 - No Over Temperature warning will be generated,
1 - Over Temperature warning will be generated.
EXAMPLES:
(EME 1) Enable broadcasting error messages
(EME+FANF 0) Disable fan fail alarm warnings
(EME?) Requests current state of broadcast. Example response is (EME!001)
Focus Lens Position Adjustment (FCS)
Adjust lens to specific focus position with a specified direction. NOTE: This command can only be used to update
the current ILS file. Changing the focus for the current channel will change the focus for any channel using the
same ILS file.
Use command without subcode:
• If ILS is ON, motor will move to specified steps, and save data to the active channel.
• If ILS is OFF, motor will move to specified steps. Do not save data to the active channel.
SUBCODE DESCRIPTION OF USE
BACN
Motor backlash in negative direction. Read-only.
BACP
Motor backlash in positive direction. Read-only.
CALB
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. SET only
command.
Cxxx
Replace Cxxx with the channel number. Valid range is 101-164.
NONE
Moving lens mount to a specified vertical position with a specified direction.
RNGN
Motor moving range in negative direction. Read-only.
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)
Appendix B: Serial API
B-5