Christie CP2230 User Manual page 30

Installation and Setup
2. Connect the Lamp Leads:
a. Open the LVPS access door and remove the four hex screws from the safety cage front panel. Lift the
front panel over the igniter.
b. Loosen the 6 screws to remove the LPS side panel.
c. Route the cables through the strain reliefs in the LPS cover.
d. Connect the positive (+) and negative (-) lamp leads to the terminals on the LPS using a torque setting
of 14ft/lbs (20N/m). DANGER! In order to prevent a fire hazard ensure the DC leads are
connected with the correct polarity and fastened to the torque setting specified.
e. Tighten the strain reliefs.
f. Route the positive and negative leads from the LPS through the two strain reliefs in the cinema projec-
tor's baseplate.
Igniter make sure the black (-) power cable (cathode lead) is securely connected with the
washers and lock washers properly in place and tighten to 175 inch-lbs, 14 ft-lbs or 20Nm
at both ends to prevent them from coming loose.
g. Connect the negative (-) black lamp lead to the negative (-) igniter terminal, left terminal. Connect the
positive (+) red lamp lead to the positive (+) igniter terminal, right terminal. CAUTION! When tight-
ening the positive and negative leads, do not tighten to the point that the brackets start to bend. Use an
adjustable wrench to support the brackets when tightening.
h. Tighten the strain reliefs.
i. Replace the igniter safety cage.
3. Move the AC Input Line Voltage switch in the upper-left corner of the LPS to the left if you are using a 200
VAC supply, or right if you are using a 400 VAC supply.
4. Connect the AC directly to the LPS with an AC Input Terminal Block that is correct for your region.
CAUTION!
ensure adequate environmental sealing and to prevent the cable from accidentally being torn out.
• For North America, Japan and most of Central/South America (
Wire Phase 1, 2, 3 and Ground
• For Europe, (380-415 VAC):
Wire Phase 1, 2, 3, Neutral and Ground
5. Connect one end of the LPS power cord into the socket on the LPS labeled CP2230/4230 cinema
projector ONLY. Connect the other end of the power cord into the socket on the front of the cinema
projector.
WARNING!
must terminate the power connector terminal block correctly to ensure 200VAC-240VAC output. These
2-14
When connecting the high current lamp leads between the LPS and the
Use an appropriately sized strain relief connector with the knockout plate provided to
If you use the power connectors to power the cinema projector or the extraction unit, you
190-208 VAC):
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)