Christie CP2230 User Manual page 125

c. Rest the anode (+) end of the lamp on the anode yoke and slip the positive lamp connector over the
bulb end. Using the 5mm Allen key, squeeze together with the anode clamp making sure not to place
any torque on the lamp quartz tube. Important! For CDXL-30SD lamps, make sure the "flat" part of
the anode end of the lamp (if applicable) is facing in the 10 or 2 o'clock position once the lamp finger
is installed in the 14mm threads and the clamp screw is tightened. For all other lamp types, keep the
"flat" part of the anode end of the lamp facing up. WARNING! Explosion hazard - Do not
apply torque to the anode end of the lamp.
d. Tighten the anode and cathode set screws.
9. Re-install the front lamp duct. As you install the front lamp
duct, lift the small light shield on the rear lamp duct cover so
that it does not get jammed between the two pieces when they
come together. (Figure 7-1) To ensure a good fit between the
two pieces, squeeze the top and bottom cover snaps to ensure
they are locked in place. The light shield should move freely to
the touch.
10. Close the internal lamp door and manually turn the 2
thumbscrews to lock it in place.
11. Turn the circuit breaker for the cinema projector on.
12. On the Touch Panel Controller (TPC), tap and hold the green
power
13. Record the new lamp information:
a. Tap Menu > Advanced Setup > Lamp History.
b. Tap Add Lamp.
c. Complete the fields in the Add Lamp dialog.
d. Tap Save.
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)
icon.
Figure 7-1 Light Shield on Front
Lamp Duct
Maintenance
7-5