Christie CP2230 User Manual page 22

Installation and Setup
Snap 3 piece airflow duct
together using stand out pins
3.
c. Insert the LPS support into the rack stand and align the pins with the holes.
d. Lift the LPS into the frame.
e. Remove the bottom 10 panels from the back of the rack stand.
f. Assemble the three piece airflow duct supplied with the LPS. First, snap the 2 "L" shaped parts
together, and then snap this into the 6 stand out pins of the third piece (flat panel).
g. Position the airflow duct directly behind the LPS.
CAUTION!
front of the lamp power supply.
h. Insert the airflow duct into the rack stand.
i. Secure the airflow duct to the rack stand using the
screws from the rack stand panels.
j. Wire all of the components in the rack stand and
replace the side panel.
k. Twist LPS cable 12 twist/meter.
5. Attach the supplied safety strap to the back of the cinema
projector and fasten it to its mounting surface. Use of the
strap is mandatory to prevent the cinema projector from
tipping when a lens or auxiliary lens mount is installed.
NOTE: If you are using the optional rack stand, it is recommended that you use the hold down clamp (116-
100101-01) in addition to the rear safety strap to firmly secure the rear feet of the cinema projector.
2-6
DO NOT install any components in
2.
Lift LPS into frame
1.
Insert support frame
Keep
Clear
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)