Installation Safety And Warning Guidelines - Christie CP2230 User Manual

Installation and Setup
ICP Faceplate Connections
The ICP board provides the image processing electronics for the cinema projector. The ICP faceplate includes
a number of LEDs that are only functional when the cinema projector is in full power mode.
• REGEN: (Regulators Enabled) Indicates the presence of the internal regulator enable signal. When illumi-
nated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) Indicates the state of the software application. When OFF, in a Fail state (0).
When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) Indicates the state of the operating system. When OFF, in a Fail state (0).
When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) Indicates the configured state of the FMT FPGA. When RED, unable to con-
figure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
• ICPST: (ICP FPGA State) Indicates the configured state of the ICP FPGA. When RED, unable to configure
FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main applica-
tion.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.
Lamp Power Supply
The Lamp Power Supply (LPS) (P/N 127-101103-XX) is an optional accessory for this cinema projector. To
connect it to the cinema projector, you use two high-current lamp leads, a RS-232 serial cable and an Interlock
(Lamp Enable) cable. You can install the LPS in the optional rack stand with the cinema projector.
The LPS provides DC power for 2.0, 3.0, 4.5 and 6.0kW lamps. A breaker on the side of the LPS acts as a
power switch, and provides protection against over-current conditions of 50A or more. If a fault occurs or
excessive voltage is detected, the breaker automatically switches OFF to prevent damage.
The LPS includes two AC power outlets that you can use to power cinema projector electronics or an approved
extraction unit. Do not use these outlets to power other devices.
2.4

Installation Safety and Warning Guidelines

WARNING
installed in a restricted access location.
WARNING
WARNING
erly handled. Always wear manufacturer approved protective safety clothing (gloves, jacket,
face shield) whenever the lamp door is open or when handling the lamp. Only qualified techni-
cians should install cinema projector lamps.
WARNING
the safety strap on the rear of the cinema projector.
WARNING
short distance. Remove the lamp before transporting the cinema projector.
2-4
QUALIFIED TECHNICIAN REQUIRED for all installations. This product must be
Never operate the cinema projector without the covers in place.
The cinema projector uses a high-pressure lamp that may explode if improp-
To prevent the cinema projector from tipping unexpectedly, you must install
Four or more people are required to safely lift and carry one projection head a
CP2230 User Manual
020-100430-07 Rev. 1 (05-2014)