Install The Primary Lens - Christie CP2230 Setup Manual

or becoming unsafe, an alarm sounds if the duct is obstructed or a fan fails. It is recommended that you
regularly verify that the exhaust is functioning correctly.
with inadequate airflow can result in dangerous overheating of the cinema projector.

2.10 Install the Primary Lens

The lens seals the projection head, preventing contaminants from entering the main electronics area. Do not
operate the cinema projector without a lens installed. Install a lens plug when you install or transport the
cinema projector.
1. Verify the rear safety strap or rear hold down bracket is installed.
2. Rotate the lens clamp to the OPEN position.
3. With the UP label facing up, insert the lens straight into the lens mount opening all the way back, without
turning.
4. Move the lens clamp to the DOWN position to lock the lens assembly.
CP2230 Setup Guide
020-100515-04 Rev. 1 (05-2014)
Never disable the vane switch. Attempting to operate the cinema projector
Figure 2-12 Open Lens Clamp and
2.
Lock
Figure 2-13 Lock Lens In Place
1.
Install Lens
Clamp
Open
Insert Lens
Clamp
Locked
Installation and Setup
2-11