Chapter 5
Cajun Campus CLI – Layer 2
Nvram initialize Command
Use the nvram initialize command to reset the Avaya P330 parameters to the
factory defaults. If no options are specified for this command, all parameters will be
reset.
The syntax for this command is:
nvram initialize [switch|all]
switch
all
Example:
P330-N# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Configure Command
Use the configure command to enter Configure Mode.
126
Resets all the switching level parameters (Layer 2 only) throughout
the stack
Resets all parameters including routing parameters of the P333R-LB
modules present in the stack
Avaya P333R-LB User's Guide