Reset Commands; Reset Command; Nvram Initialize Command - Avaya P130 User Manual

Reset Commands

Reset Command

Use the reset command to restart the P130 switch. You must type the command in
full.
The syntax for this command is:
reset {<mod_num>}
<mod_num>
Example:
P130-1# reset
This command will force a switch-over to the master module and
disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.

Nvram initialize Command

Use the nvram initialize command reset the P130 parameters to the factory
defaults. If no options are specified for this command, only the Layer 2 parameters
will be reset.
The syntax for this command is:
nvram initialize {switch | all}
switch
all
Example:
P130# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Avaya P130 User's Guide
Number of the module to be restarted
Resets all the switching level parameters (Layer 2
only)
Resets all parameters including Multilayer Policy
parameters
Chapter 6 Avaya P130 CLI
65