Chapter 6
Cajun Campus CLI - Layer 3
VLAN Commands
Table 6.6
Command
show vlan
set vlan
clear vlan
User Mode
show vlan Command
Use the show vlan command to display router Layer 2 interfaces.
The syntax for this command is:
show vlan [details]
Configure Mode
set vlan Command
Use the set vlan command to create router Layer 2 interface.
The syntax for this command is:
set vlan <vlan-id> name <vlan-name>
vlan-id
vlan-name
Example:
Router-N(configure)# set vlan 2 name vlan2
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
186
VLAN Commands
Interface Index
Interface name (used in layer 3 protocols)
Page
186
186
187
Avaya P333R-LB User's Guide