Set Radius Authentication Retry-Number Command; Set Radius Authentication Udp-Port Command - Avaya P333R-LB User Manual

Set radius authentication retry-number Command

Use the set radius authentication retry-number command to set the
number of times an access request is sent when there is no response.
The syntax for this command is:
set radius authentication retry number <retry-number>
retry-number

Set radius authentication udp-port Command

Use the set radius authentication udp-port command to set the RFC
2138 approved UDP port number. Normally, the UDP port number should be set to
its default value of 1812. Some early implementations of the RADIUS server used
port number 1645.
The syntax for this command is:
set radius authentication server udp-port <number>
Avaya P333R-LB User's Guide
Chapter 5
retry number
Cajun Campus CLI – Layer 2
135