Chapter 11
Policy
User Mode
show access-group command
Use the show access-group to see information about the configured active access
list.
The syntax for this command is:
show access-group
Example:
Router-N> show access-group
access-group 100
show ip access lists Command
Use the show ip access-lists command to see all the current policy lists.
The syntax for this command is:
show ip access-lists
Output Example:
Router-N> show ip access-lists
Router-1(super)# sh ip access-lists
The current policy source is local
default List (0) parameters
List 0 is validated - the List was not changed since the last
validation
List 0 is valid
List 0 scope is forward
default action for list 0 is permit
List 100 is not validated - the List was changed since the last
validation
List 100 status is unknown(0)
List 100 scope is forward
ip access-list 100 25 fwd5 ip
any
any range
default action for list 100 is permit
268
20
21
Avaya P333R-LB User's Guide