Table 2.2 P333R-Lb <- -> Select Buttons - Avaya P333R-LB User Manual

Table 2.1
LED Name
Rx
FDX
FC
Hspd
LAG
Table 2.2
Description
Left/Right
Reset module
Reset stack
FIV
Note: To perform "Force Initial Version," reset the module and at the same time
press the FIV reset button (use an opened paper clip or other pointed object). Let go
of the reset buttons first and then let go of the FIV button 1 or 2 seconds later.
Avaya P333R-LB User's Guide
P333R-LB LED Descriptions (Continued)
Description
Receive from line
Half/Full Duplex
Flow Control
High Speed
Link Aggregation
Group (Trunking)
P333R-LB <- -> Select buttons
Function
Individual – select LED function (see table above)
Press both right and left buttons together for approximately 2
seconds. All LEDs on module light up until buttons are
released.
Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
Force Initial Version – Boot from backup initial version of the
P330 software from Bank A (see Note below).
Chapter 2 P333R-LB Front and Rear Panels
LED Status
OFF – No receive activity
ON – Data received from the line into the
module
OFF – Half duplex mode
ON – Full duplex mode
OFF – No flow control
ON – Symmetric Flow Control mode is
enabled and port is in full duplex mode
10/100
OFF: 10
ON: 100
OFF – No LAG defined for this port
ON – Port belongs to a LAG
1000
N/A
1000
23