Chapter 5
Cajun Campus CLI – Layer 2
Set time protocol Command
Use the set time protocol command to set the protocol for use in the system as
either SNTP or TIME protocol.
The syntax for this command is:
set time protocol
Example:
P330-N# set time protocol sntp-protocol
The protocol has been set to SNTP protocol
P330-N#
The protocol has been set to TIME protocol
Set time client Command
Use the set time client command to enable or prevent the switch from
seeking the time from an external time server.
The syntax for this command is:
set time client [enable|disable]
Example:
P330-N# set time client enable
NTP client mode enable.
Set time server Command
The set time server command is used to set the TIME server address.
The syntax for this command is:
set time server <ip>
ip
96
[sntp-protocol|time-protocol]
set time protocol time-protocol
IP address of the TIME server.
Avaya P333R-LB User's Guide