Reset Mgp; Reset Wan; Nvram Initialize - Avaya P334T-ML User Manual

reset mgp

Use the reset mgp command to perform a software reset in the G700 Media
Gateway Processor.
The syntax for this command is:
reset mgp

reset wan

Use the reset wan command to perform a software reset in the X330 WAN Access
Router Module.
The syntax for this command is:
reset wan [module number][bank-a]
module
number
bank-a
Example:
To reset a WAN module residing on switch 2:
P330-N# reset wan 2
This command will force a switch-over to the wan device
and disconnect your telnet session
*** Reset *** - do you want to continue (Y/N)? y

nvram initialize

Use the nvram initialize command to reset the P330 parameters to the factory
defaults. If no options are specified for this command, only the Layer 2 parameters
will be reset.
Avaya P334T-ML User's Guidee
Optional - the module number where the WAN module to be
reset resides.
Optional - boot the WAN module from bank-a after reset.
Chapter 6 CLI – Layer 2
135